Steps to Replacing Knob and Tube Wiring in your home.
A main issue is with staircases as they can take a LONG time to wire. Some homes may have 3 flights of stairs, with all the switches and lights working together. In these instances, it may take more than an 8 hour day to run all the wires and install the boxes. So getting those lights back on at the end of the day may not be possible.
If the electrician you are hiring is telling you ALL the current knob and tube wiring will need to be off through out the entire job, look elsewhere!
What to expect from the replacement process
The first step in the process is to get an estimate from a licensed electrician.
The electrician will need to fish wiring throughout your home to replace all the old wiring. -This CAN BE DONE WITHOUT taking walls down, and without having to run surface conduits all over your house! I can’t stress this enough. We hear from many homeowners –“Wow, the last electrician said some walls down would need to be ripped down and run pipe in some spots!” It’s 100% possible to fish wiring throughout your home unless your live in some kind of cement house (my one disclaimer!).
Wallpaper can pose some issues when, as mentioned earlier in this guide, we need to make holes to fish the new wiring. Depending on the condition of the wallpaper, it can often be sliced, peeled away from the wall, then glued back. If the wallpaper won’t peel, it then typically rips.
Will I Be Without Power During My Knob and Tube Wiring Replacement?
Fortunately, the answer is no. The electrician you hire should be able to maintain most, if not all, of the power throughout your house during the process. To make this happen, the knob and tube wiring will be capped off as the electrician begins rewiring the home.
Let’s say one particular knob and tube circuit has six outlets, four lights, and four switches on it. On the electrician’s first day, he may only be able to rewire half of those items. The other half may be important for you to have on during the night. By capping the knob and tube wiring off, that circuit can be turned back on so all the power is on as it was before the electrician started. There are a few cases, especially with staircases that use three-way switches and four-way switches that, once the wiring is started, need to be finished before powering back up. In this case, you may need to go a night without those lights on. This is mainly due to the extreme difficulty in wiring these switches.